# How do I 3D print Modo enclosures?

**3D printing Modo enclosures is straightforward.** Here's the complete guide:

## What You Need:

- 3D printer (FDM type, 200x200mm bed minimum)
- PLA or PETG filament
- Slicer software (Cura, PrusaSlicer, etc.)
- Downloaded STL files from Modo

## Recommended Settings:

**Layer Height:** 0.2mm

- Good balance of speed and quality
- 0.12mm for finer details

**Infill:** 15-20%

- Adequate strength for enclosures
- Higher (30%) for stressed parts

**Walls:** 3 perimeters

- Solid outer shell
- Good thread engagement for screws

**Supports:** Usually not needed

- Modo designs minimize overhangs
- Enable for complex shapes

**Material:** PLA or PETG

- PLA: Easier to print, sufficient for most uses
- PETG: Better heat resistance, slightly stronger

## Print Times:

| Enclosure Size    | Approximate Time |
|------------------|------------------|
| Small (macro pad)| 2-4 hours        |
| Medium (keyboard) | 6-10 hours       |
| Large (panel)     | 10-16 hours      |

## Filament Usage:

- Small case: ~20-40g ($0.50-1)
- Medium case: ~50-100g ($1-2.50)
- Large case: ~100-200g ($2.50-5)

## Tips for Best Results:

1. **Bed adhesion**: Use glue stick or textured PEI
2. **Orientation**: Print lid and base separately, flat side down
3. **Cooling**: 100% fan for PLA, 50% for PETG
4. **First layer**: Slow (20mm/s) for good adhesion

## No Printer?

**3D Printing Services:**

- JLCPCB (cheapest for shipping)
- Craftcloud (price comparison)
- Local makerspaces
- Library 3D printers (often free)

Typical cost: $10-30 depending on size and material.